Heat Shrinkable Moulded Shapes
Category index of Gala's heat shrinkable moulded shapes: cable end caps, cable breakouts, rain sheds, right-angle/straight boots, military boots and anode caps.
Product Images
Covered on this page
- Cable End Caps
- Low Voltage Breakout
- Anti-Tracking Breakout
- Semi conductive Cable Breakout
- Rain Sheds
- Right Angle Boot/Straight Boot
- Anode Cap
- Heat Shrink Boot (Military Boot)
Applications
- Cable end caps
- Low voltage, anti-tracking and semi-conductive cable breakouts
- Rain sheds, right-angle/straight boots and military boots
- Anode caps
FAQs
Frequently Asked Questions
What is the Heat Shrinkable Moulded Shapes used for?
It is used for:
- Cable end caps
- Low voltage, anti-tracking and semi-conductive cable breakouts
- Rain sheds, right-angle/straight boots and military boots
- Anode caps
How is it installed?
Clean and degrease the surface, position the part, then shrink it with a gas torch or a hot-air gun: keep the heat moving round it with a smooth, brushing motion so it recovers evenly without scorching. The instruction sheet in each kit gives the full sequence step by step, including where to start shrinking.
Can I get a quote, a sample or a size that is not listed?
Send your cable details, quantity and application with the "Request a Quote or Sample" form at the foot of this page. For a size or variant that is not in the chart, describe what you need there, or use Technical support at the top of the page, and the technical team will confirm what can be supplied.
47+
Years manufacturing
100+
Countries served
140
Products in range
ISO 9001:2015
Certified & tested